RM Battery replacement

    WARNING! Follow the instructions below.

    Complete replacement of one battery before starting to replace the second battery.

    Replacing the batteries:
    • Lift the bumper and remove the batteries fuse';
    • Remove the cutting height adjustment know by lifting it upwards (figure 1)
    • Unscrew the five nuts manually at the rear side of the Chassis cover (figure 2). If you find it difficult use a wide flat screwdriver;
    • Lift the rear side of the cover (see figure 3) and disconnect only the two cables from the left battery (figure 4);
    • Place the new battery and connect the cables to the battery tabs when the red and the black cables are fitted to the color on the battery;
    • Disconnect the cables from the right battery;
    • Place the new battery and connect the cables to the battery tabs respectively to the color;
    • Place the cover back in its position and screw the five nuts manually, confirm they are tight enough;
    • Insert the batteries fuse and confirm the Robomow wakes up.
    Figure 1
    Figure 2
    Figure 3
    Figure 4